Case Report
 

By Dr. Lakshya Kumar , Dr. Ridhima Gupta , Dr. Akanksha Yadav
Corresponding Author Dr. Lakshya Kumar
Dept. of Prosthodontics, csmmu, Lucknow, Dept. of Prosthodontics, csmmu, Lucknow - India 226001
Submitting Author Dr. Lakshya Kumar
Other Authors Dr. Ridhima Gupta
Prosthodontics, Instite of Dental Sciences, Modinagar,UP, IDST,Kadrabad, Modinagar,Uttar Pradesh - India

Dr. Akanksha Yadav
Oral Medicine & Radiology, UP Dental College, - India

DENTISTRY

Maxillectomy, Permanent Liner, Permanent Denture Base

Kumar L, Gupta R, Yadav A. Prosthetic Rehabilitation of Maxillofacial Trauma Patient ? A Case Report. WebmedCentral DENTISTRY 2011;2(3):WMC001661
doi: 10.9754/journal.wmc.2011.001661
No
Click here
Submitted on: 01 Mar 2011 07:50:25 PM GMT
Published on: 02 Mar 2011 07:01:11 PM GMT

Abstract


Rehabilitation of maxillofacial trauma patients is a challenging task. The most common prosthetic treatment problem with such patients is, getting adequate retention, stability and support. The size and location of the defect usually influences the amount of impairment and difficulty in prosthetic rehabilitation.  In cases of large maxillary defect, movement of the prosthesis is inevitable. This clinical report describes method of rehabilitation of trauma patient with non invasive procedure

Introduction


The defects in maxillofacial region may result due to certain disease, pathological changes, radiation, burns, trauma or surgical intervention. The extension of defect may be small or it may include any portion of the hard and soft tissue, either intaorally or extraorally. These defects can result in hypernasal speech, fluid leakage into the nasal cavity and impaired masticatory function. The primary objectives in rehabilitating the maxillofacial trauma patients are to restore the function of mastication, deglutition and speech and to achieve normal oro-facial appearance.[1] Techniques for the prosthetic rehabilitation of these patients have been described.Patients with complete avulsion of the palate are rare, and their treatment requires a different approach with extensive surgical and prosthodontic rehabilitation. Lack of hard palate may result in speech and masticatory difficulties for the patient. The tongue is unable to make contact with a solid surface during mastication, making eating and drinking difficult and less pleasurable. Patients invariably also have cosmetic deformities such as facial collapse with loss of support of the middle third of the face, overclosure of the mandible, and a “nose-to-chin” appearance. This may be accompanied by temporomandibular joint and dental problems. Unopposed mandibular teeth tend to extrude, causing an altered occlusal plane and exposing cervical margins. These oral disabilities can be minimized by restoration with a maxillary prosthesis, which also can reduce cosmetic deformities by replacing the missing teeth and properly supporting the maxillary lip and cheek.[2]
This case presents prosthetic rehabilitation of a maxillofacial trauma patient with maxillary complete denture.

Case Report(s)


The past history of patient revealed that he met a roadside accident three years before. In that accident he has lost his eye sight as well as various fractures of the midfacial region, at that time the maxillary bone was removed because it was not restorable and later on a bone graft was placed to maintain normal contour of the maxillary bone. This surgical treatment could not result into a satisfactory outcome.
On examination, there are decreased mouth opening and poor oral hygiene. All of the mandibular teeth were present, and in maxilla only left second and third molar were present. (Figure-1) The tissue of the palatal region was mobile and tender to palpation.
The treatment plan includes surgical as well as prosthetic components. Due to failed autogenous graft, many difficulties were encountered in attempts to restore the dentition, including lack of a firm, immobile bony basal seat for denture support; no ridges and pripheral tissue, loss of the preexisting jaw relationship.An initial impression of the maxillary partially edentulous tissue was recorded in alginate impression material (Zelgan 2002, Dentsply, New Delhi, India). The cast was made (Figure-2) in type III dental stone (Kalstone; Kalabhai Industries, Mumbai, India). Two sheet of base plate wax (Modelling wax; Dental Product of India, New Delhi, India) was adapted over the residual tissue and for added retention we also added two clasps (Figure-3) over the remaining dentition (26,27). Permanent denture base was fabricated and it was inserted into the mouth. In this patient biometric guidelines can not be used successfully for the positioning of teeth (such as arch form and position, residual alveolar ridges, incisive papilla, rugae, and maxillary tuberosity)[3].So for the teeth arrangement, we used phonetics and the neutral zone concept. The arrangement of the 6 anterior teeth was first guided by esthetics & their position was verified with phonetic tests that required the patient to pronounce /s/, /f/, /v/, and /th/ sounds. According to Weinberg[4] the best positioning of the posterior teeth can be achieved by placing buccal cusp and fossa over the crest of the ridge. Because the patient had no remaining ridge to use as a guide, the posterior part of the arch form was determined to a great extent by the neutral zone, with muscular forces created during function of the cheeks, tongue, and lips. On the molded occlusal rims teeth (Figure-4) setting was done according to the functional shape produced. On delivery of the finished prosthesis (Figure-5), special attention was given on occlusal adjustments to ensure that dislodging interferences were minimized wherever possible. In an attempt to improve retention and comfort, the prosthesis was completed with a heat-polymerized permanent soft lining material (Permasoft, Dentsply, New Delhi India) on the fitting surface (Figure-6). Post insertion instructions were given to the patient for the maintenance and care of the prosthesis.

Discussion


For the rehabilitation of the maxillofacial trauma patient the approach should be multidisciplinary including the oral surgeon, Prosthodontist and oto-rhino-laryngologist. At the prosthetic phase when the artificial teeth were arranged, normal biometric guides were absent,[3] and the Prosthodontist had to rely on esthetics, phonetics, and neutral zone concepts to identify the best position for the teeth. Although literature on use of the neutral zone to improve denture retention, masticatory and speech functions, and comfort is inconclusive,in the patient described, the neutral zone was a useful aid in establishing the correct posterior tooth position. Hard acrylic resin may create a problem with soft and tender tissues through irritation. Lining the prosthesis with a soft material has been suggested.[5,6]The lining also aid in retention supplementary to clasp retention. The other treatment option includes osseointegrated implants for improved retention, stability and support but the patient has undergone such a mental trauma after the accident that he could not opt for an additional surgical procedure.

Conclusion


The patient of maxillofacial trauma patient was treated by conservative approach and the patient was adapted well to his prosthesis. He also reported that his mastication and speech had returned to near normal. Esthetics has also improved with the artificial prosthesis and patient was quite satisfied

References


1. Beumer J, Curtis TA, Firtell DN. Maxillofacial Rehabilitation. Prosthodontic and surgical considerations. C.V. Mosby Co., St Louis, Toronto. 1979 pp.183-243.
2. Beumer J, Curtis TA, Marunick MT. Maxillofacial rehabilitation: prosthodontic and surgical considerations. St. Louis: Ishiyaku EuroAmerica;1996. p. 225-9. (according to book reference style)
3. Murray CG. Anterior tooth positions in prosthodontics. Aust Dent J 1977; 22:113-119.
4. Weinberg LA. Tooth position in relation to the denture base foundation. J Prosthet Dent 1957;8:398-405.
5. Hahn GW. A comfortable silicone bulb obturator with or without dentures. J Prosthet Dent 1972;28:313-317.
6. Minagi S, Nagare I, Sato M, Sato T. Mushroom-shaped resilient retainer for maxillary obturator prostheses. Int J Prosthodont 1991;4:473-476.

Source(s) of Funding


none

Competing Interests


none

Disclaimer


This article has been downloaded from WebmedCentral. With our unique author driven post publication peer review, contents posted on this web portal do not undergo any prepublication peer or editorial review. It is completely the responsibility of the authors to ensure not only scientific and ethical standards of the manuscript but also its grammatical accuracy. Authors must ensure that they obtain all the necessary permissions before submitting any information that requires obtaining a consent or approval from a third party. Authors should also ensure not to submit any information which they do not have the copyright of or of which they have transferred the copyrights to a third party.
Contents on WebmedCentral are purely for biomedical researchers and scientists. They are not meant to cater to the needs of an individual patient. The web portal or any content(s) therein is neither designed to support, nor replace, the relationship that exists between a patient/site visitor and his/her physician. Your use of the WebmedCentral site and its contents is entirely at your own risk. We do not take any responsibility for any harm that you may suffer or inflict on a third person by following the contents of this website.

Reviews
5 reviews posted so far

maxillofacial trauma rehabilitation
Posted by Dr. Khurshid A Mattoo on 16 Apr 2011 01:24:58 PM GMT

Untitled
Posted by Dr. Mostafa I Mostafa on 21 Mar 2011 01:26:11 PM GMT

thanks a lot for the suggestions . i will try to include recent articles.... View more
Responded by Dr. Lakshya Kumar on 07 Mar 2011 07:01:31 AM GMT

Comments
0 comments posted so far

Please use this functionality to flag objectionable, inappropriate, inaccurate, and offensive content to WebmedCentral Team and the authors.

 

Author Comments
0 comments posted so far

 

What is article Popularity?

Article popularity is calculated by considering the scores: age of the article
Popularity = (P - 1) / (T + 2)^1.5
Where
P : points is the sum of individual scores, which includes article Views, Downloads, Reviews, Comments and their weightage

Scores   Weightage
Views Points X 1
Download Points X 2
Comment Points X 5
Review Points X 10
Points= sum(Views Points + Download Points + Comment Points + Review Points)
T : time since submission in hours.
P is subtracted by 1 to negate submitter's vote.
Age factor is (time since submission in hours plus two) to the power of 1.5.factor.

How Article Quality Works?

For each article Authors/Readers, Reviewers and WMC Editors can review/rate the articles. These ratings are used to determine Feedback Scores.

In most cases, article receive ratings in the range of 0 to 10. We calculate average of all the ratings and consider it as article quality.

Quality=Average(Authors/Readers Ratings + Reviewers Ratings + WMC Editor Ratings)